Anyway, luckily the ISP is much better given the price difference So for the price / quality ratio, I suggest NS2 as boss noise gate economic. Parallel DC Cord: PCS-20A Size and Weight Width 73 mmĢ-3/8 inches Weight (including battery) 415 gġ5 oz * 0 dBu = 0.775 Vrms * The specifications are subject to change without notice. I hear a lot from it and then the boss NS2 is a bad pedal, the ISP decimator is much better blah.
Leaflet ("USING THE UNIT SAFELY," "IMPORTANT NOTES," and "Information")Ĭarbon-zinc battery (9 V, 6F22) Options (sold separately) AC adaptor: PSA series *These figures will vary depending on the actual conditions of use. Signal Chain: Ibanez RGIT27FE (Drop A, EMG Equipped) Boss NS2 (X Connection Method) MXR. REDUCTION indicator Connectors INPUT jack: 1/4-inch phone typeĩV DC OUT jack Power Supply Carbon-zinc battery (9 V, 6F22) or Alkaline battery (9 V, 6LR61)ĪC adaptor (PSA series: sold separately) Current Draw 25 mA Expected battery life under continuous use Carbon: Approx. NS-2 OUTPUT > BOSS GE-7 > BOSS DD-3 > BOSS RV-3 > BBE 482 > Amp NS-2 SEND > BOSS OC-2 > BOSS PH3 > ADA INPUT ADA OUPUT > NS-2 RECEIVE LOL Crazy wiring because of all the looping I cant make one straight line of signal.
Also it has two modes - off/suppress or suppress/mute. You can put it at a specific point in your chain or you can put your fx in its loop, so that your clean signal determines whether its open or not, instead of your wet signal.
Pedal switch Indicator CHECK indicator (Serves also as battery check indicator) NS-2 is the only dedicated noise gate Ive used but I reckon its great. Nominal Input Level -20 dBu Input Impedance 1 M ohm Nominal Output Level -20 dBu Output Impedance 1 k ohm Recommended Load Impedance 10 k ohms or greater Bypass Buffered bypass Controls MODE selector switch